DT_COMPAT_SEMTECH_LLCC68_WEIHUA := "semtech,llcc68-weihua"

config LLCC68
	bool "Semtech LLCC68 LoRa Radio Driver"
	depends on SPI && GPIO
	default $(dt_compat_enabled,$(DT_COMPAT_SEMTECH_LLCC68_WEIHUA))
	help
	  Enable the Semtech LLCC68 LoRa Radio Driver.

config LLCC68_INIT_PRIORITY
	int "LLCC68 Initialization Priority"
	default 90
	help
	  The priority of the LLCC68 initialization. Lower numbers indicate
	  higher priority.

config LLCC68_MAX_PAYLOAD_LENGTH
	int "LLCC68 maximum payload length"
	default 128
	range 1 255
	help
	  Maximum radio payload length accepted by the LLCC68 driver.

	  The LLCC68 packet length fields support up to 255 bytes. Keep this
	  lower when the application has a known payload ceiling to reduce RAM
	  used by the driver's SPI staging buffers.

config LLCC68_ALWAYS_USE_SX1262_HIGH_PA
	bool "LLCC68 Always Use SX1262 High Power Amplifier"
	default y
	help
	  When enabled, the LLCC68/SX1262/SX1261 driver always chooses high
	  power amplifier settings instead of selecting them from chip version.

choice LLCC68_RF_SWITCH_DEFAULT
	prompt "Default LLCC68 RF switch mode"
	default LLCC68_RF_SWITCH_DEFAULT_AUTO
	help
	  Default RF switch mode for LLCC68 devicetree nodes that do not set
	  rf-switch-mode.

config LLCC68_RF_SWITCH_DEFAULT_AUTO
	bool "Auto"
	help
	  Preserve legacy behavior: use complementary GPIO control when both
	  tx-enable-gpios and rx-enable-gpios are present, otherwise disable RF
	  switch control.

config LLCC68_RF_SWITCH_DEFAULT_NONE
	bool "None"
	help
	  Disable RF switch control unless rf-switch-mode is set in devicetree.

config LLCC68_RF_SWITCH_DEFAULT_GPIO_COMPLEMENTARY
	bool "TXEN/RXEN complementary GPIO"
	help
	  Use MCU GPIOs for complementary TXEN/RXEN RF switch control by default.

config LLCC68_RF_SWITCH_DEFAULT_DIO2_SINGLE
	bool "DIO2 single-pin"
	help
	  Use LLCC68 DIO2 RF switch control by default. DIO2 drives TXEN, while
	  RXEN is held active externally or by rx-enable-gpios.

endchoice

module = LLCC68
module-str = llcc68

source "subsys/logging/Kconfig.template.log_config"
